PCM/ECM Reprogramming: Notes

PCM/TCM Flash Reprogramming

This procedure is required when one or more of the following situations are true:

• A Powertrain Control Module (PCM) has been replaced.
• Diagnostic Trouble Code (DTC) P1602 - PCM Not Programmed is set.
• An updated calibration or software release is available for either the PCM or TCM.

This procedure assumes that the wiTECH™ VCI Pod and StarMOBILE® devices are properly configured to the dealership network with either a wired or wireless connection. The wiTECH™ VCI Pod and StarMOBILE® must also be running the latest operating system and software release.

Table Of Contents 

-- SECTION 1 - PCM/TCM Flash Procedure SECTION 1 - PCM/TCM FLASH PROCEDURE .

-- SECTION 2 - Additional PCM/TCM Replacement Procedures SECTION 2 - ADDITIONAL PCM/TCM REPLACEMENT PROCEDURES .

-- SECTION 3 - Authorized Modification Label SECTION 3 - AUTHORIZED MODIFICATION LABEL .

-- Required Tools/Equipment REQUIRED TOOLS/EQUIPMENT .

-- Tech tips and information TECH TIPS AND INFORMATION .

-- Parts Required PARTS REQUIRED .