Fastener Tightening Specifications
| Component | Fastener Size | Nm | ||
|---|---|---|---|---|
| Automatic Transmission Fluid Pipes to Transmission Bolt | - | 20 | ||
| Automatic Transmission Fluid Cooler to Transmission Bolt | - | 36 | ||
| Bevel Box to Transmission Bolt (1) | - | 40 + 90° | ||
| Drive Axle Heat Shield Bolt | - | 40 | ||
| Ground Cable to Transmission Mount Bracket Bolt | - | 25 | ||
| Multifunction Transmission Range Switch to Selector Shaft Nut | - | 7 | ||
| Multifunction Transmission Range Switch to Transmission Bolt | - | 6 | ||
| Selector Housing to Selector Mechanism/Underbody Nut | ||||
| M6 | 8 | |||
| M8 | 20 | |||
| Selector Lever Cable Adjusting Bolt | - | 15 | ||
| Selector Lever Cable Bracket to Transmission Nut | - | 8 | ||
| Selector Lever to Selector Shaft Nut | - | 13 | ||
| Selector Mechanism to Body Bolt | - | 8 | ||
| Transmission Mount Bracket to Transmission Bolt (1) | - | 40 + 90° | ||
| Transmission Mount to Transmission Mount Bracket Bolt (1) | - | 60 + 90° | ||
|
||||
Engine to Transmission Bolt Tightening Specification
- -
Direction of Travel
- -
Drive Plate to Converter
- 60 Nm
- Quantity: 6, remove and install using the socket SW15V/175
- -
M12 Bolts
- 80 Nm
- -
M10 Bolts
- 40 Nm
- The bolts are located inside the lower flange.
- -
Arrows
- Alignment sleeves for the engine.