Handle Button, Moving Into The Installed Position

If the button was pushed in by mistake, the installed position can be set again.

There are two ways to move the button into the installed position, "with" or "without" an assembly aid. The following describes both ways.

Moving the button "with" an assembly aid into the installed position:

Make sure the assembly aid has an eye -arrow- at the front. Other assembly aids cannot be used.

Fig 1: Locating Assembly Aid Eye

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the button and push the assembly aid (with the eye) -arrow- all the way in until it latches into place. Then release the button. The button locks into the installed position when the assembly aid is pulled out.

Fig 2: Identifying Pressing Button And Pushing Assembly Aid (With Eye) All The Way In Until It Latches Into Place

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Moving the button "without" an assembly aid into the installed position: 

-- Remove the trim -A- from the handle.

Fig 3: Identifying Handle Trim

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the small lever -1- into the groove -2- with a screwdriver. This pushes the button -3- into the installed position.

Fig 4: Identifying Small Lever Pushed Into Groove With Screwdriver, Pushing Button Into Installed Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-I- the button is in the pressed position

-II- the button is in the installed position