Windshield Washer Pump V5: Notes

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Check the windshield washer pump. Refer to WINDSHIELD WASHER PUMP V5 => Checking the windshield washer pump .

NOTE:

The following illustration shows the two piece version of the washer fluid reservoir with the windshield washer pump installed. The procedure for removing and installing the windshield washer pump in a one piece reservoir is the same.

Removing

-- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

-- Loosen the front bumper cover. Refer to Removal and Installation .

-- Release and disconnect the hose connection -2- from the windshield washer pump -3- and use a suitable container to collect the washer fluid.

Fig 1: Identifying Hose Connection -2-, Windshield Washer Pump -3- And Disconnect Harness Connector -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the windshield washer pump -3- upward out of tank and disconnect harness connector -1-.

Installing

Install in reverse order of removal. Note the following:

-- Bleed headlamp washer system after completing assembly work. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .