Vehicle Electrical System Control Module -J519-

WARNING: This page is about a different variant/trim than selected.

NOTE:

It is permissible for the number of connectors to deviate from the illustration, depending on the vehicle variants.

Removal

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the footwell cover on the driver side, if equipped.

The Vehicle Electrical System Control Module -J519- is locked to the front of the relay panel on the bottom.

-- Press the catches -arrows- and swivel the Vehicle Electrical System Control Module -J519- downward.

Fig 1: Identifying Vehicle Electrical System Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the Vehicle Electrical System Control Module -J519- downward and opposite the drive direction and remove it from the bracket.

-- Disconnect the connectors.

Installation

Install in reverse order of removal. Note the following:

-- Insert the Vehicle Electrical System Control Module -J519- first with the back of the module into the bracket and push it up until it audibly latches.