U0432-00 - Invalid Data Received From Multi - Axis Acceleration Sensor Module
For a complete wiring diagram, refer to appropriate Wiring Diagram.
- >>When Monitored:<< Continuously with the ignition on, one valid CAN message received at least once.
- >>Set Condition:<< When the Anti-Lock Brake system (ABS) Module detects an incorrect CAN message from the Dynamics Sensor.
| Possible Causes |
|---|
| DYNAMICS SENSOR |
| ANTI-LOCK BRAKE SYSTEM (ABS) MODULE |
NOTE:
If present, diagnose and repair DTC C2114-16 or DTC C2114-17 before continuing with this diagnostic procedure.
Test Step 1 - VERIFY THE DTC IS ACTIVE
NOTE:
This DTC must be active for the results of this test to be valid.
- Perform any Technical Service Bulletins (TSBs) that may apply.
- Turn the ignition on.
- With the scan tool, read and record the DTCs.
- With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
- With the scan tool, erase the DTCs.
- Start the engine.
- With the scan tool, read the DTCs.
Is the DTC active at this time?
Yes
- Go to Test Step 2
No
- Perform the ABS Intermittent Condition Test. Refer to Brake System .
Test Step 2 - ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
- Replace the Dynamics Sensor. Refer to Removal and Installation .
- Perform the ABS Verification Test. Refer to Brake System .
- Turn the ignition on.
- With the scan tool, record and erase DTCs.
- Cycle the ignition switch from off to on.
- With the scan tool, read DTCs.
Is the DTC still active?
Yes
- Replace the Anti-lock Brake System (ABS) Module. Refer to Removal and Installation .
- Perform the ABS Verification Test. Refer to Brake System .
No
- Test complete.