LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2012 >> Routan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Brake System - General Information) >> General Procedures >> Brake System Bleeding >> Pressure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake System Bleeding: Pressure

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
CAUTION: Do not allow the master cylinder to run dry during the bleeding operation. Keep the master cylinder reservoir filled with the DOT 3 motor vehicle brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
NOTE: Due to the complexity of the fluid path within the rear integral parking brake calipers, it is necessary to press and release the parking brake during the bleed procedure.
  1. Clean all the dirt from the area and remove the brake master cylinder filler cap. Fill the brake master cylinder reservoir with the specified brake fluid.
    Fig 1: Identifying Brake Master Cylinder Fluid Reservoir Cap And Max Fill Line
    G03983412Courtesy of FORD MOTOR CO.
    2. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the instructions of the manufacturer when installing the adapter.
  2. Install the bleeder adapter to the brake master cylinder reservoir, and attach the bleeder tank hose to the fitting on the adapter.
    3. NOTE: Bleed the longest line first. Make sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.
    Fig 2: Locating Rubber Drain Tube On Bleeder Screw
    G03983413Courtesy of FORD MOTOR CO.
  3. Place a box end wrench on the RH rear bleeder screw. Attach a rubber drain tube to the RH rear bleeder screw, and submerge the free end of the tube in a container partially filled with clean brake fluid.
  4. Open the valve on the bleeder tank.
  5. Loosen the RH rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear bleeder screw and remove the rubber hose.
    • Press and release the parking brake 5 times.
    • Repeat until clear, bubble-free fluid comes out.
  6. Tighten the RH rear bleeder screw and install the bleeder cap.
    • To install, tighten to 10 Nm (89 lb-in).
  7. Repeat Steps  5 and  6 for the LH rear bleeder screw.
  8. Continue bleeding the front of the system, going in order from the RH front disc brake caliper bleeder screw, ending with the LH front brake caliper bleeder screw.
  9. Close the bleeder tank valve. Remove the tank hose from the adapter, and remove the adapter.
scientia non olet · About LEMON Manuals