Washer Hose Repair

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This procedure may be carried out on rubber hoses only. If a plastic washer hose is leaking, a new washer hose must be installed.

Locate and verify the leaking washer hose.
Cut the hose cleanly and remove the damaged portion of the washer hose.

Fig 1: Identifying Washer Hose Cutting Dimension
Courtesy of FORD MOTOR CO.
Install a windshield washer hose adapter between the cut ends of the hose.

NOTE: In difficult cases, clamping may be required.

Install a segment of 6.4 mm (0.25 in) ID black rubber hose over the ends of the washer hose and clamp both ends of the rubber hose using spring clamps.