Gearshift Lever: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Position the gearshift lever assembly in the vehicle.
Install the 4 gearshift lever nuts.
- Tighten to 23 Nm (17 lb-ft).
Fig 1: Locating Gearshift Lever Nuts
Courtesy of FORD MOTOR CO.
Connect the gearshift cables to the gearshift lever base.
NOTE: Make sure the gearshift cables are fully seated into the gearshift lever base or damage may occur.

Fig 2: Locating Gearshift Cables & Gearshift Lever Base
Courtesy of FORD MOTOR CO.
Connect the select cable and the shift cable to the gearshift lever.

Fig 3: Locating Select Cable & Shift Cable
Courtesy of FORD MOTOR CO.
Adjust the gearshift cables. For additional information, refer to GEARSHIFT CABLE ADJUSTMENT .
Install the LH floor console trim panel. For additional information, refer to CONSOLE -- FLOOR, FUSION, MILAN and CONSOLE -- FLOOR, MKZ .

Fig 4: Locating LH Floor Console Trim Panel
Courtesy of FORD MOTOR CO.
Install the floor console finish panel and connect the electrical connectors.
Close the storage compartment door.
Install the gearshift knob.