C1210 - G Sensor Input Circuit Performance
For a complete wiring diagram, refer to appropriate Wiring Diagram.
- >>When Monitored:<< Continuously, with ignition ON, until vehicle speed exceeds 20 km/h (12.4 m.p.h.) for the first time, but not if the sensor voltage is out of range OR, during diagnostic mode OR, if the monitoring was inhibited by a corresponding diagnostics command.
- >>Set Condition:<< If the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.
| Possible Causes |
|---|
| DYNAMICS SENSOR INSTALLATION |
| DYNAMICS SENSOR |
Test Step 1 - Test for DTC C1210 - G Sensor Input Circuit Performance
NOTE:
This DTC must be active for the results of this test to be valid.
- Turn the ignition ON.
- With the scan tool, read and record DTCs.
- With the scan tool, read and record information.
- With the scan tool, erase DTCs.
- Cycle the ignition switch from OFF to ON.
- With the scan tool, read and record DTCs.
Does the scan tool display C1210 - G Sensor Input Circuit Performance?
Yes
- Replace the Dynamics Sensor. Refer to REMOVAL AND INSTALLATION .
- Perform ABS Verification Test. Refer to ABS VERIFICATION TEST (2009 - 2011) or ABS VERIFICATION TEST (2012 & UP) .
No
- Perform the Intermittent Condition diagnostic procedure. Refer to ABS INTERMITTENT CONDITION TEST (2009 - 2011) orABS INTERMITTENT CONDITION (2012 & UP) .