B1BD1 - Roll Over Sensor Configuration Mismatch: Notes

For wiring diagram information, refer to appropriate SYSTEM WIRING DIAGRAMS article.

Theory of Operation

When powered, the occupant restraint controller performs an internal self test. The repair of this fault condition does not involve any external circuitry and centers on verifying the integrity of the module's internal circuitry and software validity.

• >>When Monitored:<< The ORC checks the status and validity of the internal operating software at power up during the initialization process, and continuously through the ignition cycle.
• >>Set Condition:<< This DTC sets when the ORC detects that roll over is configured, but not present.

Always perform the Pre - Diagnostic Troubleshooting procedure before proceeding.