Test Step 2 - Speed Control Verification Test

1. Inspect the vehicle to verify that all engine components are properly installed and connected. Reassemble and reconnect components as necessary.
2. With the scan tool, erase all DTCs.
3. Road test the vehicle at a speed more than 60 km/h (35 MPH).
4. Press the cruise On/Off switch to turn the speed control on.
5. Move the speed control switch to the Set/Decel position. If the speed control does not engage, the repair is not complete, continue with step 12.
6. Move the speed control switch to the Resume/Accel position. If the vehicle speed does not increase by 3 km/h (2 MPH), the repair is not complete, continue with step 12.
7. Using caution, press and release the brake pedal. If the speed control does not disengage, the repair is not complete, continue with step 12.
8. With the vehicle speed at least 60 km/h (35 MPH), move the speed control switch to the Resume/Accel position. If the speed control does not resume at the previously set speed, the repair is not complete, continue with step 12.
9. Move the speed control switch to the Set/Decel position. If the vehicle does not decelerate, the repair is not complete, continue with step 12.
10. Hold the speed control switch in the Set/Decel position and release the switch with the vehicle speed more than 60 km/h (35 MPH). If the vehicle speed does not adjust and set a new vehicle speed, the repair is not complete, continue with step 12.
11. With the speed control engaged, press the cruise On/Off switch. If the speed control does not disengage, the repair is not complete, continue with step 12.
12. If the vehicle did not successfully perform all of the previous steps, check for TSBs that pertain to this speed control problem and then, if necessary, return to the symptom list.
13. If the vehicle successfully performed all of the previous steps, the speed control system is now functioning as designed. The repair is now complete.

Are any DTCs or symptoms remaining?

Yes

Repair is not complete, refer to the appropriate diagnostic procedure.

Repair is complete.