Test Step 2 - Fused B(+) Circuit Open

Fig 1: Driver Window/Door Lock Switch C1 Connector

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ensure fuse M26 in the TIPM is good before proceeding.

With the scan tool, erase the DTCs.
Turn the ignition OFF.
Disconnect the driver window/door lock switch C1 connector.
Turn the ignition ON.
Using a 12 volt test lamp connected to ground, check the fused B (+) circuit in the driver window/door lock switch C1 connector.

Does the test lamp illuminate brightly?

Repair the fused B (+) circuit for an open between the switch connector and the TIPM.
Perform the Body Verification Test. Refer to BODY VERIFICATION TEST Body Exterior .

Yes