Washer Fluid Level Switch: Installing

-- Install a new grommet when installing a new sensor.

-- Assure that the flat of the sensor is aligned under the ridge of the reservoir and that the sensor connector is facing down in the fully seated position. This will allow for proper operation of the sensor float switch.

-- Connect the electrical connector to the fluid level sensor. Slide the red lock on the connector to the closed or locked position.

-- Assure that the washer hose is properly routed in order prevent pinching and possible inoperative washers.

-- Connect the right front wheelhouse liner. Refer to Removal and Installation .

-- Install the right front wheel and tire. Refer to Removal and Installation .

-- Lower the vehicle.

-- Connect the negative battery cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Verify the wiper/washer system operation.