Checking Wiring

-- Remove the Engine Control Module -J623-. Refer to the Repair Information.

-- Using a multimeter, Check the EGR Motor 2 -V339- / Exhaust Gas Recirculation Position Sensor 2 -G466- electrical harness connector to the Engine Control Module - J623 - electrical harness connector T60 for an open circuit.

Specified value: 1.5 Ω Max.

If the specified value was Not obtained:

-- Check the wiring connection for an open circuit, high resistance, short circuit to Battery (+) or, Ground.

-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to Final Procedures 

If the specified value was obtained:

-- Replace the EGR Motor 2 -V339- /Exhaust Gas Recirculation Position Sensor 2 -G466-. Refer to the Repair Information.

-- Go to Final Procedures 

-- Remove the Engine Control Module -J623-. Refer to the Repair Information.

-- Using a multimeter, Check the EGR Motor 2 -V339- /Exhaust Gas Recirculation Position Sensor 2 -G466- electrical harness connector to the Engine Control Module -J623- electrical harness connector T94 for an open circuit.

Specified value: 1.5 Ω Max.

If the specified value was Not obtained:

-- Check the wiring for an open, high resistance or short to ground.

-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to Final Procedures 

If the specified value was obtained:

-- Replace the Engine Control Module -J623-. Refer to the Repair Information.

-- Install the engine cover. Refer to the Repair Information.