Measuring Procedure

Start

→

Perform wheel run-out compensation.

→

Bounce vehicle

↓

Turn the steering wheel into the straight ahead position and secure it ⁽¹⁾

←

Measure vehicle height

←

Install Brake Pedal Actuator VAG1869/2

↓

Check camber at front axle

→

Is actual value within tolerance?

→

↓

←

Yes

Adjusting, refer to ADJUSTING FRONT CAMBER

↓

←

↓

Check rear axle camber

→

Is actual value within tolerance?

→

↓

←

Yes

Adjusting, refer to ADJUSTING REAR CAMBER

↓

←

↓

Check toe at rear axle

→

Is actual value within tolerance?

→

↓

←

Yes

Adjusting, refer to ADJUSTING REAR TOE

↓

←

↓

Check caster at front axle

→

Is actual value within tolerance?

→

↓

←

Yes

Check the axle components and assembly

↓

←

↓

Check toe at front axle

→

Is actual value within tolerance?

→

↓

End

←

Yes

Adjusting, refer to ADJUSTING FRONT TOE

↑

↓

↑

←

⁽¹⁾	If steering wheel is crooked at end of alignment procedure, it must be straightened. Perform a basic setting on the Steering Angle Sensor -G85- using the Vehicle Diagnostic Tester.