General Repair Information: Transmission

WARNING: This page is about a different variant/trim than selected.

Always make sure that no dirt enters an "open" transmission. Dirt entering an open transmission can cause a malfunction especially with a "open" Mechatronic unit and/or oil pump.

Do not run the engine and do not tow the vehicle if the transmission front cover is removed or if there is no Direct Shift Gearbox (DSG®) oil inside the transmission.
Always clean the connecting points and the areas around them first, and then loosen them.
When installing the transmission, make sure the alignment sleeves are correctly seated between the engine and transmission.
Place removed parts on a clean surface and cover them so that they do not get dirty. Use foil, paper or a lint free cloth.
Only install clean components: Only unpack replacement parts immediately prior to installation.
If the transmission is replaced, check the DSG® oil level and fill as necessary, refer to DSG® OIL LEVEL, CHECKING . For the correct capacity, refer to CAPACITIES .