Information Bus: Service and Repair

Data Bus On Board Diagnostic Interface (J533)

The data bus on board diagnostic interface is located in the right side of the driver footwell near the steering column.

Before removing the data bus on board diagnostic interface, the work procedure to read out the codes stored in the module must always be performed. Refer to => [ Data Bus On Board Diagnostic Interface (J533), Replace ] Data Bus On Board Diagnostic Interface (J533), Replace.

• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the lower trim on the driver side.

- Disconnect the connector - 1 - from the data bus on board diagnostic interface - 2 -.






- Press the tabs - 3 - together - arrows - and pull them out of the holes.

- Remove the data bus on board diagnostic interface - 2 -.

Installing

Install in reverse order of removal.