If the Specified Value Was Obtained
-- REMOVE: Engine Control Module -J623-. Refer to appropriate service information.
-- CHECK: Engine Speed Sensor -G28- electrical connector to the Engine Control Module -J623- electrical connector T60.
| Engine Speed Sensor -G28- electrical connector terminals: | Engine Control Module -J623- electrical connector T60 terminals: |
|---|---|
| 2 | 51 |
Specified Value: 0.5 Ω (± 0.3 Ω)
If the specified value was Not obtained:
-- CHECK: wiring for an open, high resistance or short
-- CHECK: wiring connection for damage, corrosion, loose or broken terminals
-- REPAIR: faulty wiring or connection
-- GO TO: Final Procedures
If the specified value was obtained:
-- REMOVE: Engine Speed Sensor -G28-
-- CHECK: sensor wheel for proper seating, damage and/or run - out. Refer to appropriate service information.
If sensor wheel is OK:
-- REPLACE: Engine Speed Sensor -G28-. Refer to appropriate service information.
-- GO TO: Final Procedures