Multifunction Transmission Range Switch -F125-: Installing

Install in the reverse order of removal. Note the following:

-- Install the Multifunction Transmission Range Switch -F125- -4- to the selector shaft -6-.

Fig 1: Identifying Selector Shaft Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts -5- for the switch hand tight.

-- Bend back the hooks on the lock washer -2-.

-- Install the washers -2 and 3- on the selector shaft -6-.

-- Install the washer -2- with the hooks facing up.

-- Install the washer -2- with the long narrow guide into the long narrow depressions in the selector shaft -6-.

-- Tighten the nut -1- to 7 Nm.

-- Tighten the nut -1- and secure it by bending the hook on the washer -2- downward.

-- Replace the lock washer if a hook breaks off.

-- Install the selector shaft lever -3- onto the selector shaft -4-.

Fig 2: Identifying Selector Shaft Lever Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the selector shaft lever -3- into the "P" position. This means, push the selector lever -3- opposite the drive direction until it stops.

-- Move the lever -3- into the "N" position. Push the lever -3- two positions forward in the direction of travel.

-- Adjust the Multifunction Transmission Range Switch -F125-. Refer to Adjustment Prerequisites .