Checking Wiring
-- Remove the Engine Control Module (ECM) -J623-. Refer to the Repair Information.
-- Using a multimeter, Check the Camshaft Position (CMP) Sensor -G40- electrical harness connector to the Engine Control Module (ECM) -J623- electrical harness connector T60 for an open circuit. Refer to Wiring Diagrams for pin locations.
| Camshaft Position (CMP) Sensor -G40- electrical harness connector terminals: | Engine Control Module (ECM) -J623- electrical harness connector T60 terminals: |
|---|---|
| 1 | 44 |
| 3 | 52 |
Specified value: 1.5 Ω Max.
If the specified value was Not obtained:
-- Check the wiring connection for an open circuit, high resistance or short circuit to voltage or ground.
-- Check the wiring connection for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
-- Go to Final Procedures
If the specified value was obtained:
-- If no faults were found, Replace the Engine Control Module -J623-. Refer to the Repair Information.
-- Go to Final Procedures