Transmission Code Letter, Reading

The transmission code letters are on the transmission in at least two different locations.

On the transmission near the selector lever cable -arrows-.

Fig 1: Locating Additional Code Letters (Some Transmissions)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

If these cannot be read, the transmission code letters under the transmission mount bracket can also be read.

To read the code letters under the transmission mount bracket, the engine and transmission must be supported. The transmission mount bracket -A- must be removed. Lower the engine/transmission just enough until it is possible to slide the bracket toward the rear. If lowered further, the pendulum support could be damaged. After being assembled, the selector lever cable must be adjusted, refer to SELECTOR LEVER CABLE, ADJUSTING .

Fig 2: Identifying Left Assembly Mounting Console

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Removing the Transmission Mount Bracket:

-- Remove the air filter housing, refer to one of the following:

with a gas engine, refer to [For engine(s) CPRA, CPKA] Removal and Installation [For engine(s) CDVB] Removal and Installation .

with a diesel engine, refer to[For engine(s) CKRA] Removal and Installation [For engine(s) CVCA] Removal and Installation .

-- For vehicles with a diesel engine, remove the battery and the battery tray, refer to [For engine(s) CVCA, CDVB, CPRA, CBTA, CPKA, CKRA, CBUA] Removal and Installation .

Fig 3: Identifying Battery Housing Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install the Engine Support Bridge 10-222A and support engine/transmission. Do not lift up yet.

-- Remove the transmission mount to transmission mount bracket bolts -2- and the transmission mount bracket to transmission bolts -2-.

Fig 4: Identifying Transmission Support Plate And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

All the bolts must be replaced.

-- Then, lower the engine/transmission slightly using the Engine Support Bridge 10-222A spindles until the transmission mount bracket can be removed.

In most cases, 2 turns on the spindles are enough to remove the transmission mount bracket -arrow-.

Fig 5: Identifying Transmission Support Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

After reading the transmission code letters, reassemble in the reverse order of removal.

-- Follow all instructions.

-- Replace all the bolts for the transmission mount/bracket.

-- Install all the new bolt hand tight.

-- Install the transmission mount bracket -A- to the transmission bolts -1- and the transmission mount to transmission mount bracket bolts -2-. Tightening specifications, refer to ENGINE AND TRANSMISSION MOUNTS OVERVIEW .

Fig 6: Identifying Transmission Support Plate And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- After installing the transmission mount bracket, adjust the selector lever cable, refer to SELECTOR LEVER CABLE, ADJUSTING .