Engine, Removing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Be sure to obtain the radio anti-theft code, because it will be necessary to disconnect the battery ground cable later in the procedure.
The engine is removed downward together with the transmission.
All cable ties which are opened or cut off when removing the engine, must be replaced in the same position when installing the engine.
CAUTION:
Note the following whenever working inside the engine compartment due to limited space:
- Route all lines and cables in their original locations.
- Ensure sufficient clearance to all moving or hot components.
Special tools and workshop equipment required
- Hose Clamps - Up To 25 mm 3094
- Engine/Trans. Support T10012
- Torque Wrench 1331 5-50 Nm VAG1331
- Torque Wrench 1332 40-200 Nm VAG1332
- Engine/Gearbox Jack VAG1383A
- Step Ladder VAS 5085
- Hose Clip Pliers VAS6340
- Shop Crane - Drip Tray VAS6208
- Transportation Lock T10404