Ignition System
To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:
- Do not touch or remove ignition wires when the engine is running or turning at starter speed.
- Only disconnect and reconnect wires for the injection and ignition system, including test leads, if the ignition is turned off.
- The fuel pump is activated by turning on the ignition and by the drivers door contact switch. If the battery was not disconnected, the connector -arrow- must be disconnected from the fuel delivery unit or the fuse for the fuel pump control module must be removed before opening the fuel system.
CAUTION:
Note the following whenever working inside the engine compartment due to limited space:
- Route all lines and wires in their original locations.
- Ensure sufficient clearance to all moving or hot components.