New Control Module, Installing
WARNING:
Excessive shaking (e.g. dropping, impact) may destroy the control module. Control module must then no longer be used.
- Surface must be cleaned before assembling.
-- Slide all sealing rings -A- slightly over the valve dome.
-- Place control module without canting it onto hydraulic unit.
Sealing rings are then brought into their end position.
-- Install the hydraulic unit and control module with the new inner Torx bolts diagonally according to the tightening specification.
NOTE:
A new control module may be installed a max. of two times to a used hydraulic unit, to ensure that the elastic gasket seals sufficiently.
A control module which was once in driving operation must not be installed a second time.