Mass Airflow Sensor -G70-, CHECKING: Notes

Observe all safety precautions: SAFETY PRECAUTIONS 

View clean working conditions: CLEAN WORKING CONDITIONS 

Special tools and workshop equipment required 

• Multimeter.
• Wiring diagram.

Test requirements 

• The fuse is OK.
• Battery voltage at least 12.5 volts.
• All electrical consumers such as, lights and rear window defroster, switched off.
• Vehicles with automatic transmission, shift selector lever into position "P" or "N".
• A/C switched off.
• Ground connections between engine/transmission/chassis OK.
• Coolant Temperature at least 55° C.
• Ignition switched off.

Test procedure 

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK .

Start diagnosis 

-- Connect the scan tool.

-- Start engine and let idle.

-- Using the scan tool, Check the air flow quantity of the Mass Air Flow (MAF) Sensor -G70- at idle:

Diagnostic text		Specified value
Air flow quantity at Mass Air Flow (MAF) sensor
Engine running at idle		2.00 to 5.00 g/sec

-- Switch the ignition OFF.

If the specified value was obtained: 

-- Condition may be intermittent

-- Check the intake duct for air leaks, loose connections.

-- Check the wiring for an open, high resistance or short to ground.

-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to Final procedures

If the specified value was Not obtained: 

-- Disconnect the Mass Air Flow (MAF) Sensor -G70- electrical harness connector.

-- Switch the ignition On.

-- Using a Multimeter, Check the Mass Air Flow (MAF) Sensor -G70- electrical harness connector terminal 5 to Ground (GND) for voltage.

Specified value: Battery Voltage

-- Switch the ignition OFF.

-- Continue test according to the following table: 

Value	Cause	Test
If the specified value was not obtained:	Open or shorted circuit	Checking wiring
If the specified value was obtained:	Check reference signal circuit	Checking wiring