Lock Cylinder
Only the driver door still has a lock cylinder.
Removing and installing the left lock is described here. Removing and installing a right lock cylinder is identical.
Removing
- Lock cylinder cap has been removed, refer to LOCK CYLINDER COVER CAP .
-- Remove the covers -4 and 6-.
-- Remove the bolt -5-.
-- Turn the screw -7- until it stop and press the screw in -arrow a-, so that the bracket -8- releases the lock cylinder.
-- Remove the lock cylinder housing -1- from the bracket -3- at a right angle -arrow b- to the door.
Installation
-- Insert the lock cylinder housing -1- into the bracket -3- at a right angle.
-- Install the bolts -5 and 7- into the mounting bracket.
-- Screws -5 and 7- tightening specification: 4 Nm.
During installation, lock cylinder housing must be pressed onto the outer door panel.
Further installation is in reverse order of removal.
- Then, always perform a function test with door opened.