Transmission Fluid, Checking

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench (5-50 Nm) V.A.G 1331
Triple Square Socket Driver 3357
For the correct transmission fluid, refer to the relevant maintenance information.

-- Remove the noise insulation. Refer to Description and Operation .

-- Remove the oil fill plug -arrow- in order to check the transmission fluid level.

Fig 1: Identifying Sealing Plug For Gear Oil Inspection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The level is correct when the transmission fluid comes up to the bottom edge of hole.

-- Install the plug -arrow- with a new seal.

-- Tighten the plug -arrow- to specification, refer to Fig 2.

Note the following when filling for the first time:

-- Remove the oil fill plug -arrow-.

-- Add transmission fluid until it reaches the lower edge of the hole.

-- Install the plug -arrow- with a new seal.

-- Tighten the plug -arrow- to specification, refer to Fig 2.

-- Install the noise insulation. Refer to Description and Operation .

Fig 2: Identifying Different Versions Of Oil Drain Plugs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

I - Plug with a multi-point socket head, 45 Nm

II - Plug with hex socket head, 30 Nm