Checking Wiring
-- Remove the Engine Control Module -J623-. Refer to the Repair Information.
-- Using a multimeter, check the Transmission Control Module (TCM) -J743- electrical harness connector to the Engine Control Module -J623- electrical harness connector T94 for resistance.
| Transmission Control Module (TCM) -J743- electrical harness connector terminals: | Engine Control Module -J623- electrical connector T94 terminals: |
|---|---|
| 15 (Can-Bus Low) | 67 |
| 10 (Can-Bus High) | 68 |
Specified value: 1.5 Ω Max.
If the specified value was not obtained:
-- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground.
-- Check the wiring connection for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-- Replace the Selector Lever -E313-. Refer to the Repair Information.