LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2012 >> Beetle Turbo, 2.0L Eng VIN 6, Automatic DCT Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 2.0L - Generic Scan Tool - Engine Code: CCTA (Hatchback) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Camshaft Adjustment Valve 1, Checking >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK 

Start diagnosis

-- Disconnect Camshaft Adjustment Valve 1 -N205- electrical harness connector.

-- Using a multimeter, check the terminals of the Camshaft Adjustment Valve 1 -N205- for resistance.

Specified value: 5.0 to 9.0 Ω (at approx. 20°C)

If the specified value was Not obtained:

-- Replace the Camshaft Adjustment Valve 1 -N205-. Refer to the Repair Information.

If the specified value was obtained:

Checking voltage

-- Switch the ignition ON.

-- Using a multimeter, Check the Camshaft Adjustment Valve 1 -N205- electrical harness connector terminal 1 to engine ground for voltage.

-- Switch the ignition OFF.

Specified value: Battery voltage.

If the specified value was Not obtained:

-- Check the wiring connection for an open circuit, short circuit to Ground.

-- Check the wiring connection for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection and replace any open fuses.

If the specified value was obtained:

scientia non olet · About LEMON Manuals