| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
-- Was Complaint verified? |
- NO:
- Gather more Information from customer about the complaint
|
| 2 |
- DISCONNECT: Secondary Air Injection Sensor 1 -G609- electrical connector
- IGNITION: ON
- CHECK: Secondary Air Injection Sensor 1 -G609- wiring connector terminals 1 to 3 for voltage
- SPECIFIED VALUE: About 5.0 V
- IGNITION: OFF
-- Was value obtained? |
|
| 3 |
- REMOVE: Secondary Air Injection Sensor 1 -G609- Refer to appropriate service information.
- CHECK: Secondary Air Injection Sensor 1 -G609- electrical connector terminals 4 to the Engine Control Module - J623- electrical connector terminals T60 / 55.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
- YES:
- REPLACE: Secondary Air Injection Sensor 1 -G609- Refer to appropriate repair information.
- GO TO: Step 5
- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 5
|
| 4 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Secondary Air Injection Sensor 1 -G609- electrical connector terminals 1 to the Engine Control Module - J623- electrical connector terminals T60 / 13.
- CHECK: Secondary Air Injection Sensor 1 -G609- electrical connector terminals 3 to the Engine Control Module - J623- electrical connector terminals T60 / 44.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
- YES:
- REPLACE: Engine Control Module (ECM) -J623-. Refer to the Repair Information.
- GO TO: Step 5
- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 5
|
| 5 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
- NO:
- Repair is complete, Generate readiness code. Refer to READINESS CODE .
- Return vehicle to Customer
|