LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2012 >> Beetle Base, 2.5L Eng VIN X, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 2.5L - Generic Scan Tool - Engine Code(S): CBTA & CBUA (Hatchback) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> CAN BUS Terminal Resistance, Checking >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK .

-- Disconnect the Data Bus On Board Diagnostic Interface -J533- electrical harness connector.

NOTE: The Engine Control Module -J623- must remain connected for the following step.

-- Disconnect the Data Bus On Board Diagnostic Interface -J533- electrical harness connector.

-- Using a multimeter, check the Data Bus On Board Diagnostic Interface -J533- electrical harness connector terminals 18 to 19 for the correct Terminal Resistance. Refer to appropriate Wiring Diagrams for pin locations.

Specified value: 60 to 72 Ω (at approx. 20 °C)

If the specified value was Not obtained:

scientia non olet · About LEMON Manuals