LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2012 >> Beetle Base, 2.5L Eng VIN P, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 2.5L - Generic Scan Tool - Engine Code(S): CBTA & CBUA (Hatchback) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Oxygen Sensor After Three Way Catalytic Converter -G130-, Checking >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK .

Start diagnosis

-- Perform the function test in Diagnostic Mode 06.

If specified Mode 6 values are obtained:

-- Switch the ignition Off. Generate the readiness code.

If the specified value was Not obtained:

-- Remove the retaining screws and the cover.

Checking primary voltage

-- Disconnect the Oxygen Sensor After Three Way Catalytic Converter -G130- electrical harness connector.

-- Switch the ignition ON.

-- Using a multimeter, check the Oxygen Sensor After Three Way Catalytic Converter -G130- electrical harness connector terminals 3 to 4 for voltage.

Specified value: 0.400 to 0.500 Volts

-- Switch the ignition OFF.

If the specified value was obtained:

-- Replace the Oxygen Sensor After Three Way Catalytic Converter -G130-.

If the specified value was Not obtained:

scientia non olet · About LEMON Manuals