Thread Inserts, Inserting

Thread Inserts, Inserting

- Turn the threaded insert - 3 - onto the spindle until the drive peg - 2 - makes contact on drive tab - 1 - of installing spindle.






• Thread insert must be able to be turned easily.

- Screw the threaded insert into the threaded plate until the threaded insert is seated flush with the outer edge of the threaded plate (check visually).






- Then tighten the threaded insert by a 1/4 turn further.

- Remove the spindle.

- Break off thread insert driver tang using tang breaker.






- Install the subframe (tightening specification). Refer to => Suspension, Wheels and Steering 40 Removal and Installation.