Engine Speed Sensor: Service and Repair

Engine Speed Sensor (G28)

Removing

- Remove the engine cover. Refer to => [ Engine Cover ] Service and Repair.

- Open the charge air pipe hose clamp - 2 -.






- Disconnect the electrical connector - arrow -.

- Remove the noise insulation.

- Remove the bolts - 1 and 4 - and remove the charge air pipe downward from the throttle valve control module.

- Remove the charge air hose by loosening the clamps - 1 and 2 -






- Disconnect the engine speed sensor connector - 1 -.






- Remove the engine speed sensor bolts and sensor.

Installing

Install in the reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Ignition System Component Overview ] Service and Repair.