Anti-Lock Brake Module: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ABM, HCU And Solenoid Valve Stems

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.

-- Align components and install the ABM (1) on the HCU (2).

-- Install the four screws (1) attaching the ABM (2) to the HCU. Tighten the mounting bolts to 3 Nm (27 in. lbs.).

Fig 2: Identifying ABM Mounting Screws

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.

-- Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.

Fig 3: Identifying ABM Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the negative cable on the battery negative post.

-- Hook up the scan tool to initialize the ABM and perform the following:

-- Clear any faults.

-- Perform the ABS Verification Test and road test the vehicle. Refer to BRAKE SYSTEM .