Express Windows Auto Up, Reprogramming

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Volkswagen Routan, 2013 Volkswagen Routan, 2012 Volkswagen Routan, 2011 Volkswagen Routan, and 2010 Volkswagen Routan. However, it is still accessible from the selected car via links, so may be relevant.

Anytime the battery is disconnected or in a run down/low voltage state, the auto-up (express) windows must be calibrated.

To calibrate the auto-express feature, perform the following:

-- Turn the ignition to the Run position.

-- Using the scan tool, perform an ECU reset.

-- Position the window at the midpoint of travel.

-- Move the driver side front window upward until the window stalls in the full up position. Allow the window motor to stall for at least 2 seconds before releasing the switch.

-- Move the driver side front window downward until the window stalls in the full down position. Allow the window motor to stall for at least 2 second before releasing the switch.

-- Repeat steps 3, 4 and 5 for the passenger side front window.

-- Verify the windows are properly calibrated by operating the express down and up features. Repeat this procedure if the calibration failed. If unable to properly calibrate after the second attempt, check the drivers door module and passengers door module for diagnostic trouble codes and correct as required.