Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to a scan tool. This information needs to be downloaded into the new module once installed. For additional information, preform MODULE CONFIGURATION article.

NOTE: A new driver seat module (DSM) is delivered in a manufacturing mode with a pre-set DTC of B2477 (Module Configuration Failure). This DTC will clear when the module has been successfully configured during programmable module installation (PMI).

NOTE: This step is only necessary if the DSM is being replaced.

Upload the module configuration information from the DSM. For additional information, preform MODULE CONFIGURATION article.
Remove the driver seat. For additional information, preform SEATING article.
Remove the 2 screws.
Disconnect the 2 electrical connectors.
Remove the DSM from the seat bracket.

NOTE: Once the new module is installed, it is necessary to download the module configuration information from the scan tool into the new module. For additional information, preform MODULE CONFIGURATION article.

To install, reverse the removal procedure.