Service Interval Display: Coding At Delivery Inspection (For USA And CANADA)

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Switch on the ignition.

-- Touch the "GUIDED FAULT FINDING" button/field on the screen.

NOTE:

If the displays indicated in the procedure are not shown on the display, refer operating instructions for Vehicle Diagnostic Tester or Vehicle Diagnostic Tester.

-- Select the following one after the other:

Brand
Type
Model year
Engine code

-- Confirm the VIN.

If the vehicle identification procedure was performed correctly, press > button for confirmation.

-- Select the following one after the other:

Body
Electrical Equipment
01 - On Board Diagnostic (OBD) capable systems
"Instrument cluster" -ARROW-.

Fig 1: Diagnosis System Display: 17 - Instrument Panel Insert
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Instrument cluster functions
"Adapt Service Interval Display".

NOTE:

Check which intervals are set.

Intervals must be set or recoded for first oil change service at 5, 000 miles/8, 000 km.

-- Perform Adaptation according to instructions from "GUIDED FAULT FINDING".

Note for vehicles from MY 07:

NOTE:

The following applies to USA and Canada vehicles:

Channel 50: 50 (= 5, 000 miles) for USA

Channel 50: 80 (= 8000 km) for CDN

Channel 51: 372 (= 372 days) for USA and CDN

When coding to QG0 or QG2: Channels 42 + 49 are not available and are replaced with channels 50 + 51.

Furthermore, when coding QG0, QG2, channels 43, 44 and 49 are deactivated

Ending the adaptation:

Indicated on display:

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the End button -arrow- on the display.

-- Turn off the ignition and disconnect the diagnostic connector.