New Control Module, Installing
WARNING: This page is about a different variant/trim than selected.
WARNING:
Excessive shaking (e.g. dropping, impact) may destroy the control module. Control module must then no longer be used.
- Surface must be cleaned before assembling.
-- Slide all sealing rings -A- slightly over the valve dome.
-- Place control module without canting it onto hydraulic unit.
Sealing rings are then brought into their end position.
-- Bolt hydraulic unit and control module with new inner Torx bolts supplied.
NOTE:
A new control module may be assembled on an already used hydraulic unit twice at maximum in order to guarantee the seal of the elastic gasket.
A control module which was once in driving operation must not be installed a second time.