Instrument Cluster, Replacement
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Work procedure "replace instrument cluster" contains the following scope of work:
- If a new instrument cluster is installed in the vehicle, the Instrument Cluster Control Module -J285- must be adjusted to the various equipment characteristics and corresponding version for that country.
- To adapt the integrated Anti-theft immobilize control module -J362- with the Engine Control Module -J623- (ECM), it is necessary to save the data from the engine control module in the replacement instrument cluster.
- Also, all ignition keys must be adapted after installation of a new instrument cluster.
Procedure
-- Connect the Vehicle diagnostic tester.
-- Select Guided Fault Finding .
-- Use the GO TO button to select the "function/component selection" and the following menu options one after the other:
- Body
- Electrical Equipment
- 01 - On Board Diagnostic (OBD) capable systems
- Instrument Cluster
- Instrument cluster functions
- Instrument cluster, adaptation/replacing