RNS 315+

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Trim removal Wedge 3409

NOTE:

Replacement part number for RNS (Radio Navigation System) is located on a sticker on the radio housing.

Always deactivate the anti-theft code when replacing the RNS (Radio Navigation System).

Removing

CAUTION:

Turn off the ignition and all electrical consumers.
Remove the key.

-- If there is a CD still in the player, remove it. Refer to the Owner's Manual.

Only Jetta MY 2012

-- Remove the cover -2- from the instrument panel -1- using 3409.

Fig 1: Identifying Cover -2- From Instrument Panel -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

All except Jetta MY 2012

-- Remove the upper cover and vents from the center of the instrument panel. The screws under the center console should now be accessible. Refer to Removal and Installation .

All Vehicles

-- Remove the bolts -arrows-.

Fig 2: Identifying Bolts -Arrows-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the center console cover -arrows- using 3409.

Fig 3: Identifying Center Console Cover -Arrows- Using 3409

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows-.

Fig 4: Identifying Screws -Arrows- In Radio/Navigation Display Unit Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the radio/navigation display unit control module out of the installation slot just far enough until the connectors on the back are accessible.

-- Squeeze the connector lock in direction of the -arrows-.

Fig 5: Identifying Electrical Connection Lock

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the locking bracket in the direction of the -arrow- and remove the connector.

Fig 6: Identifying Mounting Bracket Rotated Up And Disconnected Electrical Connection

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unlock the antenna connections -arrows- and disconnect the connectors.

Fig 7: Identifying Direction To Disengage Antenna Cable Electrical Connection Lock

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unlock and disconnect the USB connection

Installing

Install in reverse order of removal. Note the following:

NOTE:

Never push on the display or the buttons on the radio/navigation display unit control module when installing it. It will be damaged.

-- Install the screws -arrows- in the radio/navigation display unit control module.

Fig 8: Identifying Screws -Arrows- In Radio/Navigation Display Unit Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Anti-Theft Coding, Deactivating, refer to ELECTRONIC ANTI-THEFT SYSTEM, DEACTIVATING .

-- Check the coding for the radio/navigation display unit control module and code it again if necessary. Refer to RNS 315+ COMPONENTS, ADAPTING .

Torque specifications: 1.5 Nm