IPOD BASEPLATE -R192-, Troubleshooting

Special tools and workshop equipment required 

• Hand-Held Multimeter V.A.G 1526C
• Connector Test Kit V.A.G 1594C

The iPod baseplate does not have OBD.

The voltage supply can be checked at the connector.

Test Conditions 

• iPod OK, refer to the Operating Instructions.
• iPod RESET performed, refer to the Operating Instructions.
• Fuse OK.
• Radio/RNS no faults using Vehicle diagnostic tester.

Procedure 

-- Remove the iPod baseplate. Refer to IPOD BASEPLATE -R192- .

-- Disconnect the connector under the iPod baseplate.

-- Turn on the radio/RNS

-- Measure the voltage between contacts 3 and 6 as well as between contacts 3 and 8 on the wiring harness connector using V.A.G 1526C and the cables from the V.A.G 1594C.

Specified value: approximately 12 V.

-- Turn off the radio/RNS.

Voltage values not OK:

-- Check the wire connection between the radio and the iPod baseplate according to the wiring diagram.

Voltage values OK:

-- Replace the iPod baseplate.