Comfort System Central Control Module -J393-

WARNING: This page is about a different variant/trim than selected.

The "replace and code the comfort system central control module" procedure must always be performed to read the codes that are stored in the module before the comfort system central control module is removed. Refer to REPLACING AND CODING, THROUGH MY 09

CAUTION:

Turn off the ignition and all electrical consumers.
Remove the key.

Removal

-- Remove the glove compartment. Refer to Removal and Installation .

-- Pull the tab -1- on the bracket for the comfort system central control module in -direction of arrow- and slide the comfort system central control module until the holes -2- lines up over the holes -3-.

Fig 1: Pulling Retaining Tab Of Bracket Of Comfort System Central Control Module J393 And Sliding Comfort System Central Control Module J393

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The connectors can only be disengaged and disconnected when the recesses -arrows- of the connectors and bracket line up exactly.

Fig 2: Identifying Recesses Lined Up

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors.

NOTE:

The number of connectors depends on the vehicle equipment.

-- Remove the nuts -arrows-.

Fig 3: Comfort System Central Control Module Bracket Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket and the comfort system central control module.

-- Pull the tab -1- in -direction of arrow B- and slide the comfort system central control module -2- out of the bracket in -direction of arrow A-.

Fig 4: Pulling Retaining Tab And Sliding Module From Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installation

Installation is performed in the reverse order of removal. Note the following:

Connectors can only be released and disconnected when the openings -arrows- on the connectors and on the bracket line up exactly.

Fig 5: Identifying Recesses Lined Up

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

After installing a new comfort system central control module, it must be coded. Refer to THROUGH MY 09, CODING .