Vehicle Electrical System Control Module -J519- Replace
WARNING: This page is about a different variant/trim than selected.
The work procedure "replace the vehicle electrical system control module" contains the following scope of work:
- If a new vehicle electrical system control module is installed, it must be coded online.
- The factory mode in the vehicle electrical system control module is deactivated.
- All of the remote keys are programmed again.
- Body
- Electrical Equipment
- On Board Diagnostic (OBD) capable systems
- vehicle electrical system control module
- Vehicle electrical system control module functions
- Replace the vehicle electrical system control module
The procedure to "replace the vehicle electrical system control module" can only be performed with the Vehicle diagnostic tester in the "guided fault finding" function.
Procedure
Connect the 1/21/2 Vehicle diagnosis, testing and information system VAS 5051.
Select Guided Fault Finding .
Use the GO TO button to select the "function/component selection" and the following menu options one after the other: