Windshield Wiper System
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always follow the instructions regarding disconnecting and connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
General Information
The Wiper Motor Control Module -J400- is integrated with the Windshield Wiper Motor -V-.
To remove wiper blades, wiper arms must be driven into "service/winter position". The "service/winter position" is activated by operating the windshield wiper lever in the "one-touch wiping" position within 10 seconds after switching off the ignition.
Additional information:
- Refer to the Owner's Manual.
DTC Recognition and Display
The Vehicle Electrical System Control Module -J519- is equipped with OBD.
Use the Vehicle diagnostic tester under "Guided Fault Finding".