Multifunction Transmission Range Switch -F125-: Adjusting

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Adjustment Prerequisites

• Selector lever cable is disconnected at the selector shaft lever
• The selector shaft is in the "N" position.
• The bolts on the multifunction switch have been loosened.
• The lever/selector shaft is removed.

Perform the following procedure:

-- Install the T10173 on the selector shaft -2- and turn the multifunction switch -1- just until the T10173 locks onto the tab on the connector on the multifunction switch.

Fig 1: Identifying Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the bolt -3- to secure the T10173 to the selector shaft -2-.

-- Tighten the bolts -arrows- to 6 Nm.

-- Remove the T10173.

-- Further installation is performed in the reverse sequence, refer to Installing .