Shift And Selector Cables: Notes
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Lubricate the bearing areas and the sliding surfaces. Use the correct grease.
- Selector Shaft with Selector Cover
- (Shift unit)
- Clip
- For the relay lever -17-.
- Transmission Shift Lever
- Install so that the master spline aligns with the shift rod. Refer to Fig 2.
- To install, lubricate first, refer to Fig 3.
- Adjust the shift mechanism after installing. Refer to SHIFT MECHANISM, ADJUSTING .
- Installed position, refer to Fig 4.
- Cable Retainer
- For attaching the shift cable -8- to the transmission shift lever -3-.
- Adjust the shift mechanism after installing. Refer to SHIFT MECHANISM, ADJUSTING .
- Do not interchange, the cable locking mechanisms for the selector cable on the relay lever and for the shift cable to the transmission shift lever are different. Refer to Figure.
- Lock Washer
- Always replace after removing.
- Nut
- 23 Nm
- Always replace after removing.
- Self-locking
- Lock Washer
- Always replace after removing.
- Be careful not to damage the cables when removing them.
- Shift Cable
- Attach to the cable retainer -item 4-
- Installed position, refer to SHIFT AND SELECTOR CABLES, INSTALLED POSITION .
- Selector Cable
- Attach to the cable retainer -item 19-.
- Installed position, refer to SHIFT AND SELECTOR CABLES, INSTALLED POSITION .
- Shift Housing
- Lock Washers
- Always replace after removing.
- Be careful not to damage the cables when removing them.
- Cable Bracket
- Made of plastic.
- Bolt
- 20 Nm
- For securing the cable bracket to the transmission.
- Quantity: 2
- Grommet
- For the cable bracket to the transmission.
- Spacer
- Nut
- 20 Nm
- For securing the cable bracket to the transmission.
- Relay Lever
- Made of plastic.
- Installed position, refer to Fig 4.
- Remove and install together with the cable retainer -item 19
- To install, lubricate, refer to Figure.
- Adjust the shift mechanism after installing. Refer to SHIFT MECHANISM, ADJUSTING .
- On the shift cover, disconnecting and reconnecting, refer to Figure.
- Sliding Shoe
- Cable Retainer
- For attaching the selector cable -9- to the relay lever -17-.
- Adjust the shift mechanism after installing. Refer to SHIFT MECHANISM, ADJUSTING .
- Do not interchange, the cable locking mechanisms for the selector cable to the relay lever and for the shift cable to the transmission shift lever are different.
- Removing from the selector cable. Refer to Fig 5.
- Allocation, refer to Figure.
- Removing from the relay lever -17-, refer to Figure.
- Installing onto the relay lever -17-, refer to Figure.
- Locking Pin
- For adjusting the shift mechanism. Refer to SHIFT MECHANISM, ADJUSTING .
-- When installing the transmission shift lever, make sure the tooth gap -arrow A- is placed over the missing selector shaft teeth -arrow B-.
- Lubricate the selector lever guide rail -B-, into which the relay lever engage, especially carefully.
NOTE:
The illustration of the transmission shift lever may differ from the original part.
- Transmission shift lever with balance weight
- Clip
- The relay lever fits into the guide rail on the transmission shift lever via the sliding shoe -arrow-.
-- Pull the locking mechanism all the way forward -arrow 1- and lock it in the -direction of arrow 2-.
-- Remove the cable -B- from the cable retainer -A-.