Engine Speed Sensor -G28-: Removing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation, refer to Overview - Herbie Beetle Decorative Film .

-- Disconnect the electrical connector -1- using the Elbow Assembly Tool T10118.

Fig 1: Identifying Electrical Connector And Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

To release the connector without the Elbow Assembly Tool T10118:

With a screwdriver push the connector for the engine speed sensor.

Simultaneously lift up on the release tab with a thin wire hook.

-- Remove the bolt -2-, and remove the Engine Speed Sensor -G28-.