LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2011 >> Jetta Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (2.0L - Engine Assembly - Engine Code: CVCA (Convertible)) >> 10 Engine Assembly >> Removal And Installation >> Transmission Mount >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Mount: Installing

WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Replace the bolts that were tightened with an additional turn after removing them.

-- Secure the transmission support to the longitudinal member.

CAUTION: Risk of damaging threads in transmission support by inserting bolts crooked.
  • The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts. Push the transmission up using a floor jack if necessary.
  • Only remove the Engine Support Bridge 10-222A when bolts for subframe mount are tightened to tightening specification.

-- Pull the transmission up using the spindle on the engine support bridge until the transmission support touches the transmission mount support arm.

-- Check the adjustment of the assembly mounts, refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the Engine Support Bridge 10-222A from the engine.

scientia non olet · About LEMON Manuals